PARTS WASHER Productivity |
|
|
|
| StingRay pump systems upgrades for the parts washer are available from 20 horsepower up to the 140 quadroplex. |
The StingRay fresh hot water rinse system provides a heated fresh water rinse at end of each wash cycle to remove remaining detergent. |
Protect parts from corrosion and flash rust with the injector system. |
|
|
|
| The Remote Grease fittings on StingRay Aqueous Parts Washers simplify the necessary maintenance |
The StingRay automatic lubrication system ensures critical bearings are properly lubricated on a regular basis |
Enables manual rinsing of spot areas after a wash cycle |
| TURNTABLE CAPACITY |
TURNTABLE JOG |
HOUR METER |
Higher rated capacities increase the work that can be performed in the parts washer |
Convenient panel mounted industrial control for easy rotation of the turntable during parts loading. |
Panel mounted hour meter maintains parts washer operating hours. |
| HIGH-LOW PRESSURE SWITCH |
PUMP AMP METER |
STAINLESS STEEL CABINET |
Selectable output pressure of duplex equipped pumping systems |
Panel mounted digital display tracks parts washer pump amp draw. |
All standard wetted components are stainless steel |
PARTS WASHER Configuration |
|
|
|
| Eliminate steam from your StingRay parts washer with the Automatic Steam Exhaust (ASE) system |
Washes and rinses hollow diameter parts where the interior is not ready accessible to standard spray manifold arms. |
Two machines in one. A standard machine and a shorter ultra high impact machine. |
|
|
|
| The Hot Air Blow Off (HABO) system speed dries parts |
Speeds flash drying of parts at lower cost than Hot Air Blow Off with near equal results. |
The Pump Pressure Regulator allows the operator to adjust the pressure discharge from the wash nozzles. |
|
|
|
| Provides the necessary changes to the parts washer to operate with the identical performance parameters as 60 Hertz. |
Parts washers for worldwide use |
Choice of heating systems to fit your plant energy source |
PARTS WASHER Solution Management |
|
|
|
| Oil skimmer removes surface waste oils floating on the parts washer cleaning solution surface. |
The Sludge Scraper removes sludge, rocks, sand, soil and other solid wastes from the bottom of the parts washer reservoir |
Filters all parts washer fluid before discharging through the wash nozzles. |
|
|
|
| Separates waste oil from Parts Washer cleaning solution |
The StingRay solution transfer pump is especially designed for transferring water-based liquids, fluids and solutions from the parts washer. |
Ideal pump for handling all parts washer solutions and for clean out of your industrial parts washer. |
PARTS WASHER Safety |
|
|
|
| Reduces noise from pump motor. |
Add safety control to the parts washer for employee protection |
Secondary Containment, industry best practice for preventing reportable spill |
PART WASHER Material Handling |
|
|
|
| Provides a convenient loading means mounted to the parts washer. |
Positions parts for optimum cleaning improve rinsing, and drainage for best flash drying |
Simplifies placing smaller items on the parts washer turntable for cleaning |
PARTS WASHER Energy Conservation
|
|
|
|
Saves Energy, lowers cost to heat machine. Reduces noise |
Increases Safety, Conserves Energy and Improves Productivity |
Properly sized pumps for the correct power density for the parts clean work save energy |
Parts Washers 
